Installation guide

After you select Switch to AP Mode, the Ralink utility icon

will indicated the DP Wireless-N PCI Adapter is operating

in AP mode. If you want to switch the DP Wireless-N PCI

Adapter back to station mode (become a client of other

wireless access points), click Switch to Station Mode.

Config

Figure 13

SSID: Please input the SSID (the name used to identify this

wireless access point) here. Up to 32 numerical characters

can be accepted here, excepting space.

TX Rate: Please select the data transfer rate here. The

maximum TX rate you can select here depends on the

wireless mode you’re using. It’s safe to select Auto to let

DP Wireless-N PCI Adapter select a proper TX rate according

to the strength and quality of radio signal. When the

wireless mode is set to 802.11 B/G/N Mix, TX Rate will be

set to Auto and cannot be changed.