Operation Manual

Original User Guide | Impulse 2.0 Pedelec Version 3 EN-67
To wake from sleep mode
1. Press the battery button for one second. The following appears:
Display Description
    
Therst,second,third,fourthandfthLEDscomeoninorderandthenall
goo.
2. The battery has now "woken up".
IfnoLEDashes,orall5LEDsashseveraltimes,the
battery may be faulty  9.2 Battery P. EN-83.
Initiating sleep mode (seat tube battery)
1. Press the battery button twice. The following appears:
Display Description


TherstandfthLEDsashtwice.
2. The battery is now in sleep mode.
7.4 Assembly
IMPORTANT
Graspthebatteryrmly, so that it does not fall out of your hand. It
can be damaged if you drop it.
Seat tube battery
Display Description Capacity

3 – 5 LEDs light up The battery has a capacity of over 60%

0 – 2 LEDs light up The capacity of the battery is below 60%.
Down tube battery
Display Description Capacity
5. LED
1. LED

The 1st LED lights
up.
The battery has a capacity
of over 60%

The 5th LED lights
up.
The capacity of the battery
is below 60%.
If fewer than three LEDs come on, or the 5th LED lights up,
the battery may need to be replaced. To discuss the next
steps speak to your DCW/RU dealer.
7.3.1.3 Sleep mode
To prevent a total discharge, the battery management
system (BMS) switches the battery to sleep mode. After
ten days (seat tube battery) or after two days (down tube
battery), your battery will revert to sleep mode depending
on the charge level.