Operation Manual
Original User Guide | Impulse 2.0 Pedelec Version 3 EN-53
Test display
It is advisable to access the test display in order to clearly identify pixel
errors.
1. In the main menu, navigate to the option "Version" as described under
6.8.1.2 Navigating within a menu P. EN-45. This shows the current
display and motor software.
2. Brieypressthe
button. The test display is shown.
3. Brieypressingthe
button takes you back to the option "Version" in
the main menu.
Display serial number of the motor
1. In the main menu, navigate to the option "Version" as described under
6.8.1.2 Navigating within a menu P. EN-45. This shows the current
display and motor software.
2. Brieypressthe
button. The serial number of the motor will be
displayed.
3. Brieypressingthe
button takes you back to the option "Version" in
the main menu.
6.8.2.13 Update
Path: Device settings I Other I Update
"Memory card required" - in this area, DCW/RU dealers can carry out a
software update.
1. Pressing the
button returns you to the sub-menu 2 level.
6.8.2.11 Factory settings
Path: Device settings I Other I Factory settings
1. In the main menu, navigate to the option "Factory settings" as
described under 6.8.1.2 Navigating within a menu P. EN-45.
2. The following question appears on the display: "Reset factory
settings?"with"Yes"and"No"underneath.
3. Select the required option using the
/ buttons. The selection is
highlighted in bold.
4. Conrmyourselectionbybrieypressingthe
button. You will return
to the sub-menu 2 level.
6.8.2.12 Version
Path: Device settings I Other I Version
If you want to display the name of the current software version on your
display and motor, proceed as follows:
1. In the main menu, navigate to the option "Version" as described under
6.8.1.2 Navigating within a menu P. EN-45. This shows the current
display and motor software.
2. Pressing the
button returns you to the sub-menu 2 level.
Ask if there is a software update for your pedelec in the
course of regular maintenance checks listed in the service
book.