Operation Manual

Original User Guide | Impulse 2.0 Pedelec Version 3 EN-27
3.10.1.3 Quick-release axle
*
Removing the front wheel
1. Remove the pedelec battery.
2. Open the quick-release lever on the
frontwheelbyturningitdown180˚.
3. Hook the quick-release lever into the slot and turn it anticlockwise
until the quick-release axle protrudes from the axle hole about 1 cm.
4. Lift out the front wheel and remove the quick-release axle.
IMPORTANT
Detach all cables from the wheel (e.g. lighting cables), otherwise you
could tear them.
If your bike is fitted with rim brakes you must release them.
Alternatively, you can deflate the front tyre. Otherwise you
may not be able to remove the front wheel.
5. Remove the front wheel.
Quick-release clamp
2. Open quick-release clamp
Replacing the front wheel
1. Apply a thin layer of grease to the quick-release axle.
2. Push the wheel into the front forks
and align with the axle holes.
3. Reinsert the quick-release axle.
4. Move the quick-release lever to the open position.
5. Hook the quick-release lever into the slot and turn it clockwise.
This screws the axle into the thread. Make sure that your wheel is
correctly centred.
6. Closethequick-releaseleverbyturningitup180˚.
DANGER
Closing the quick-release lever should be so hard that you need to use
the ball of your hand to do it. If not, it can open and loosen the wheel
while you are riding the bike,
whichcouldresultinyoufallingothe
bike.
Quick-release clamp
6. Close quick-release clamp
*depending on model