Operation Manual

Original User Guide | Impulse 2.0 Pedelec Version 3 EN-25
3.10 Wheel
3.10.1 Changing the wheel
3.10.1.1 Axle nut
*
Removing the rear wheel
1. Remove the pedelec battery.
2. Change the gear to the one
recommended by the gear
manufacturer for disassembly.
3. Remove the gear shift cable from the
rear wheel.
4. Undo the axle nuts using a 15 mm
spanner, turning anticlockwise.
5. If necessary remove the brake anchor.
6. Takeothebelt/chain.
7. Remove the rear wheel.
Replacing the rear wheel
1. Attach the belt/chain.
2. Insert the rear wheel centrally in the drop-outs as far as it will go.
3. Re-attach the gear shift cable.
4. If necessary fasten the brake anchor.
5. Tighten the axle nuts using a 15 mm spanner, turning clockwise. Make
sure that your wheel is correctly centred.
6. Reinsert the battery.
4.
Undo axle nuts
Axle nut
3. Remove shift cable from rear wheel
Shift cable
3.10.1.2 Quick-release wheels
*
DANGER
Quick-release lever and
brake disc clash
wrong
Front wheel: The quick-release lever must be
positioned on the opposite side to the brake disc
(wheretted).If the quick-release lever is on
the same side as the brake disc, there is a risk
that they can clash and lock the front wheel (see
diagram), which can cause a serious accident.
Allquick-releaseclampsmustbecorrectlytightenedbeforeyouseto,
otherwise the components can loosen – if that happens while riding you
couldfalloanditcouldresultinseriousinjury.
Removing the front wheel
1. Remove the pedelec battery.
2. Open the quick-release lever by turning
it down 180°. You will now usually be
able to see the word 'OPEN' on the
inside of the lever.
3. Carefully undo the adjustment nut,
turning it anticlockwise.
Quick-release clamp
Adjustment nut
2. Open quick-release clamp
*depending on model