Operation Manual

Original User Guide | Impulse 2.0 Pedelec Version 3 EN-17
3.2 Adjusting the saddle height
3.2.1 Determining the correct saddle height
1. Sit on the pedelec and at the same time lean
against a wall.
2. Turn the pedal crank on the side away from
the wall to its lowest point.
3. Put your heel on the pedal.
Your leg should be fully extended.
4. Raise the saddle if your leg is not fully extended when your heel is
on the pedal. Lower the saddle if you cannot reach the pedals. The
following sections explain how to adjust the saddle height on your
bike. The saddle post can be fastened using the saddle clamp
 3.2.2 Adjusting the saddle height: Saddle clamp(s)* P. EN-17 or quick-
release lever  3.2.3 Adjusting the saddle height: Quick-release clamps*
P. EN-18.
WARNING
Saddle post marking
There is a mark on the saddle post showing the
maximum amount you can pull the saddle post
out of the frame. Never pull out the saddle post
beyond this mark, otherwise it can buckle or
breakandyoucouldfallo.
3. Extend leg
3.2.2 Adjusting the saddle height: Saddle clamp(s)
*
1. Loosen the saddle clamp(s) by turning it
anticlockwise with an Allen key.
2. Move the saddle post to the desired
position.
3. Tighten the saddle clamp(s) again by
turning it clockwise
 10. Torque settings P. EN-86.
4. Test the tightness of the saddle by trying
to move it.
1. Loosen the saddle clamp(s)
3. Tighten the saddle clamp(s)
*depending on model