Specifications

12
Integration instructions for host product manufacturers according to KDB 996369 D03
OEM Manual v01
2.2 List of applicable FCC rules[and ISED Radio Standards Specifications]
CFR 47 FCC PART 15 SUBPART C has been investigated. It is applicable to the modular.
2.3 Specific operational use conditions
This module is stand-alone modular. If the end product will involve the Multiple simultaneously
transmitting condition or different operational conditions for a stand-alone modular transmitter
in a host, host manufacturer have to consult with module manufacturer for the installation
method in end system.
2.4 Limited module procedures
Not applicable
2.5 Trace antenna designs
Not applicable
2.6 RF exposure considerations
This equipment should be installed and operated with minimum distance of 20cm from your
body
2.7 Antennas
This radio transmitter FCC ID: 2AF6B-RAK4600H has been approved by Federal
Communications Commission to operate with the antenna types listed below, with the
maximum permissible gain indicated. Antenna types not included in this list that have a gain
greater than the maximum gain indicated for any type listed are strictly prohibited for use with
this device.
Antenna No.
Operate frequency band
Antenna Type
Maximum antenna
gain
Antenna 1
902 GHz – 928 GHz
External Antenna
3.00 dBi
Antenna 2
2402 MHz – 2480 MHz
External Antenna
3.00 dBi
2.8 Label and compliance information
The final end product must be labeled in a visible area with the following" Contains FCC ID:
2AF6B-RAK4600H
2.9 Information on test modes and additional testing requirements
Host manufacturer is strongly recommended to confirm compliance with FCC requirements for
the transmitter when the module is installed in the host…
2.10 Additional testing, Part 15 Subpart B/ Canadian CAN ICES-003 (B) disclaimer
Host manufacturer is responsible for compliance of the host system with module installed with
all other applicable requirements for the system such as Part 15 B