User's Manual
Table Of Contents
- 1.0 PREFACE
- 2.0 INTRODUCTION
- 3.0 USING BCADMIN™
- _
- 3.1 SCREEN LAYOUT
- 3.2 ANATOMY OF A CONNECTION LINE
- 3.3 CONFIGURING INDIVIDUAL BREADCRUMBS
- 3.4 RADIO SETTINGS
- 3.5 REACHBACK SETTINGS
- 3.6 FORWARDING SETTINGS
- 3.7 SECURITY
- 3.8 BCADMIN PREFERENCES
- 3.9 MAPPING WITH FUGAWI TRACKER
- 4.0 DEPLOYING THE BREADCRUMB WIRELESS LAN
- 6.0 Troubleshooting
XL, XLE, XLV BreadCrumb
®
User Guide Rajant Corporation
3.5.6. IP ADDRESS CONFIGURATION
If 'Obtain an IP Address Automatically’ is selected for a Gateway Mode, the BreadCrumb device will obtain its
IPv4 address on its reachback interface using DHCP.
If ‘Use the Following:’ is selected for a Gateway Mode, the following must be set manually:
• a. IP Address
• b. Subnet Mask
• c. Default Gateway
• d. DNS Server (You may need to contact your network administrator in order to determine the
correct settings.)
3.6 FORWARDING SETTINGS
The ‘Forwarding’ tab contains controls for configuring inbound NAT translation for BreadCrumb
devices configured as gateways.
Figure 15. BreadCrumb Properties – Forwarding Tab
- 27 -