User's Guide

ESD CABLE SPECIFICATION

Cable Dimensions 26cm length

Terminal Material Copper

Attachment Procedure End of ESD Cable tied to Earth Ground

Ordering Information

②

CODES Connectors type Carton Dimension

WLM200N5-26ESD 7B0000 MMCX

For 50pcs (pcs/ctn), 0.40m * 0.22m * 0.085m / 0.006 = 1.5KG

For 250pc (pcs/ctn), 0.45m * 0.45m * 0.24m / 0.006 = 8.1KG

Module grounding cable included

Configurations are subject to change without notice

Please contact Compex sales representatives for other available configurations

COMPLIANCE INFORMATION

FCC NOTICE

This device has been tested and found to comply with the limits for a Class B digital device,

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation. This device generates, uses

and can radiate radio frequency energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If this device does cause

harmful interference to radio or television reception, the user is encouraged to try to correct

the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Connect the computer into an outlet on a circuit different from that to which the receiver is

connected.

• Increase the separation between the computer and receiver.

• Consult the dealer or an experienced radio/TV technician for help.

Caution: Any changes or modifications not expressly approved by the grantee of this device

could void the user's authority to operate the equipment.

FCC Compliance Statement: This device complies with Part 15 of the FCC Rules.

Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and

2. This device must accept any interference received, including interference that may cause undesired

operation.

This device must accept any interference received, including interference that may cause

undesired operation.

IEEE 802.11a or 802.11n operation of this product in the U.S.A. is firmware-limited to

channels 1 through 24.

RF exposure warning

The equipment complies with FCC RF exposure limits set forth for an uncontrolled

environment.

The equipment must be installed to provide a separation distance of at least 20cm from