User's Manual
Table Of Contents
- 1.0 PREFACE
- 2.0 INTRODUCTION
- 3.0 USING BCADMIN™
- _
- 3.1 SCREEN LAYOUT
- 3.2 ANATOMY OF A CONNECTION LINE
- 3.3 CONFIGURING THE BREADCRUMB
- 3.4 RADIO SETTINGS
- 3.5 REACHBACK SETTINGS
- 3.6 FORWARDING SETTINGS
- 3.7 SECURITY
- 3.8 BCADMIN PREFERENCES
- 3.9 MAPPING WITH FUGAWI TRACKER
- 4.0 DEPLOYING THE BREADCRUMB WIRELESS LAN
- 6.0 Troubleshooting
Rajant Corporation ME BreadCrumb User Guide
- 32 -
3.9 MAPPING WITH FUGAWI TRACKER
BCAdmin has the ability to relay position information from BreadCrumb devices (either manually set by an
administrator or obtained via GPS) to the Fugawi Tracker mapping application. Each BreadCrumb device’s asset
ID within Fugawi Tracker is its BreadCrumb ID as reported by BCAdmin.
To enable the relaying of position information, open the Preferences dialog shown above and provide the
following information:
1. Fugawi Tracker IP Address
ThisistheIPv4 address of the workstation running the Fugawi Tracker application.
2. Fugawi Tracker Port
ThisistheIPv4portonwhichFugawiTrackeris listening for TCP connections (default is 800).
3. Fugawi Tracker Password This is the password configured within Fugawi Tracker that BCAdmin
must use upon connecting. 3.0 DEPLOYING THE BREADCRUMB WIRELESS LAN.