User's Manual
Table Of Contents
- FCC and IC Statements
- Copyright Statement
- Preface
- 1 Introduction
- 2 Using BC|Commander or BCAdmin
- 3 Deploying the BreadCrumb Wireless Network
- 4 BreadCrumb LX/LX3 USB Firmware Upgrade
- 5 Troubleshooting
- Appendix A: Error and Warning Codes
- Appendix B: Using Pole Mount Bracket
Rajant Corporation BreadCrumb
®
LX/LX3 User Guide
03-100101-001 Version: 2.91
Tip
The process of zeroizing keys and restoring factory defaults can also be performed
remotely from within the BC|Commander/BCAdmin management software. For
details on this alternative method, refer to the BC|Commander/BCAdmin user
guide.
1.3.6.2 LED Configuration
This mode is used to control the default and alternate display states of the Status LED. The LED
Configuration function is accessed by pressing the switch and releasing it after a two second hold.
The default state of the Status LED is defined as the state that the LED is in after a BreadCrumb has
been reset and has completed its boot process. The user can then toggle between the alternate and
default states of the Status LED by pressing the switch and activating the LED Configuration
function.
The default display state of the Status LED is dictated by the LED mode setting that is configured
from BC|Commander (please refer to the BC|Commander User Guide document for a more detailed
description of the LED mode setting).
Table 8 illustrates the possible default and alternate display states of the Status LED.
Table 8: Default and alternate display states of the Status LED.
Default State Alternate State
ON OFF
ALERTS ONLY ON
OFF ON
Note that state changes can occur only between options in the same rows of the table above. For
example, it is possible to toggle the state back and forth between ALERTS ONLY and ON, but not
between ALERTS ONLY and OFF. Transitioning from ALERTS ONLY to OFF would require
changing the LED mode setting in BC|Commander.
The Status LED is capable of displaying alerts, error codes, and link states. When the LED is ON,
errors, warnings, and link status are displayed. When the LED is OFF, errors, warnings, and link
states are not displayed. When the LED is set for ALERTS ONLY mode, only warnings and errors
are displayed.
Warning
The LED remains active until the completion of the boot process. The LED may
display information during the boot process even with the LED mode set to OFF.
The LED must be physically masked (such as adding tape to the LED lens) to
guarantee that no light is emitted at any time.
13