User's Manual
Table Of Contents
- FCC and IC Statements
- Copyright Statement
- Preface
- 1 Introduction
- 2 Using BC|Commander or BCAdmin
- 3 Deploying the BreadCrumb Wireless Network
- 4 BreadCrumb LX/LX3 USB Firmware Upgrade
- 5 Troubleshooting
- Appendix A: Error and Warning Codes
- Appendix B: Using Pole Mount Bracket
BreadCrumb
®
LX/LX3 User Guide Rajant Corporation
Version: 2.91 03-100101-001
1.3.3 Antenna Connectors
The BreadCrumb LX provides two Type N female antenna connectors. The connector located on the
front side of the enclosure (see F in Figure 3) interfaces to the 2.4 GHz antenna. The connector
located on the the back side of the enclosure (see B in Figure 4) interfaces to the 900 MHz, 2.4 GHz,
4.9 GHz or 5 GHz antenna depending on the BreadCrumb LX model.
8
A: ½” Closure Plug (Not Utilized). (LX)
Type N RF Connector for the 2.4 GHz or 5 GHz Antenna (Not Shown). (LX3)
B: Type N RF Connector for the 900 MHz, 2.4 GHz, 4.9 GHz or 5 GHz Antenna. (LX)
Type N RF Connector for the 900 MHz or 5GHz Antenna (LX3)
Figure 4: BreadCrumb LX/LX3 Enclosure Features (Bottom-Rear Side).