User's Manual

Rajant Corporation BreadCrumb
®
LX User Guide
Version 1.06 June 25, 2008
- 24 -
5.1.2.2 USING OVER-THE-AIR FLASH (continued)
3. The installation of the firmware can be started immediately, by left clicking on Open Folder.
NOTE: Before proceeding any further, make sure that the BreadCrumb(s) that are being updated have been
turned on.
4. On the BCAdmin screen, put in the location of where the Firmware Update File was saved to. Left click
on Firmware Update. If you want to “auto-retry firmware transfer until successful?” The update should
be successful on the first update attempt, but just in case, left click Yes.
5. On the BCAdmin screen, while the BreadCrumb is being updated, it will show the firmware update
percentage transferred, as seen in the figure below.
NOTE: Do NOT turn off the BreadCrumb during the firmware update process.
NOTE: Although, a percentage indication is seen while the firmware is being copied to the BreadCrumb, the
actual ‘installation’ does not take place until after the firmware is copied. After the firmware is copied,
installation can take up to another two (2) minutes. When firmware installation is complete, the
BreadCrumb will reboot. The BreadCrumb reboot can take a little more than one (1) minute.