User's Manual
Table Of Contents
- FCC and IC Statements
- Copyright Statement
- Preface
- 1 Introduction
- 2 Using BC|Commander
- 3 Deploying the BreadCrumb Wireless Network
- 4 BreadCrumb JR OTA Firmware Upgrade
- 5 Troubleshooting
- Appendix A: Error and Warning Codes
Rajant Corporation BreadCrumb
®
JR User Guide - PRELIMINARY
20-100035-001 Version: 1.00-pre1
4. Power ON the device.
5. Wait approximately 90 seconds for the device to boot.
6. Power ON the BC|Commander PC.
7. Start BC|Commander.
8. The BC|Commander console should display the first BreadCrumb.
9. Determine the approximate location for the next BreadCrumb.
10.Proceed to the location for this BreadCrumb, observing the network in BC|Commander as
you progress.
(a) If the BreadCrumb loses network connectivity before you reach its destination, backtrack
until network connectivity is restored. The point at which network connectivity for this
BreadCrumb is restored is most likely the farthest point in this direction at which you will
be able to place this BreadCrumb.
(b) If you reach the destination without losing connectivity you can place it there.
i. At this point, you may choose to proceed farther in an attempt to make optimal use of
the available BreadCrumbs.
ii. If so, proceed until network connectivity is lost and then backtrack until network
connectivity is restored for this BreadCrumb. The point at which network
connectivity is restored for this BreadCrumb is most likely the farthest point in this
direction at which you will be able to place this BreadCrumb.
11.Repeat steps 9 and 10 for any remaining BreadCrumbs.
17