User's Guide

146 Failed to verify consistent country settings
147 The configured countries are not consistent
151 Premanufacturing install process failed
152 Firmware install failed
153 Postmanufacturing install process failed
154 The autorun is missing required symbols
21
Recovery log detected. To clear this message, please take a diagnostic snapshot and
upload to https://secure.rajant.com.
22
Internal error detected. Please take a diagnostic snapshot and upload to
https//secure.rajant.com. This message will be cleared on the next reboot.
Code SelfTest Codes (3*)
31 Hardware configuration not set. Factory initialization required.
311 Hardware error detected.
32 BreadCrumb has been zeroized.
321 BreadCrumb is being zeroized.
33 Radio(s) not detected.
331 Radio in MANUAL compliance mode is violating country regulation.
332 Spectrum Access not granted
333 Low Battery
334 Gas gauge not initialized. To initialize, please power off unit and fully charge.
335 Noncompliant radio configuration in use
34 Cannot read /dev/nand6 information, or cannot resize or format /dev/nand6.
36 Hardware monitor missing.
37 Failed to configure ethernet port
38 Resetting radio due to error.
381 Noise floor threshold exceeded
382 Radar detection paused radio