User manual

Ride7 for ARM Debugging with Hardware Tools
- 27 -
4.2.2.1 RLink jumpers
When using a starter kit’s embedded RLink (no plastic casing), ensure that your jumpers are set
correctly on the RLink. To do this, click on "View RLink jumper configuration for STRx". The
following illustrations showing the STRx configuration for the RLink jumpers is displayed:
Note: If the pictures in this document differ from those in Ride7, assume that those shown in
Ride7 are correct.
If you purchased RLink as part of an STRx or STM32 starter kit (such as the REva evaluation
board for STRx), then the jumpers should already be correctly set. For this reason, you should
only need to adjust these jumpers if they were accidentally unplugged, or if you are using an
RLink that was configured for another microcontroller such as ST7.
4.2.2.2 Instant actions
This section of the dialog box allows you to carry out the instant actions listed below without
leaving this dialog box. This is useful for testing connections and retrieving information from the
RLink and your ARM, as well as for programming the ARM and its configuration.
• “View RLink REva jumpers configuration for STRx” shows you how you must set the
jumpers on RLink for using it for programming and debugging STRx. You must be sure
that the jumpers are correctly set before launching a debug session, or using any of the
instant actions below.