User manual

Debugging with Hardware Tools Ride7 for ARM
- 24 -
4.1 Selecting hardware debugging tools
Within Ride7, you can choose your target hardware debugger either in the Project Options
window if it is opened or with the "Options" -> "Project Properties" menu selecting -> Advanced
ARM Options -> "Debug Environment".
From the Debug Tool option you can choose between a list of available tools.
Ride7 ARM supports RLink or JTAGjet for debugging and programming of STRx and STM32
microcontrollers.
Select the tool corresponding to your debugging hardware:
RLink
If you have an RLink connected to the target STRx or STM32 on your
application board via a JTAG connector, or if you are using the REva
evaluation board, which includes an embedded RLink.
JTAGjet
If you have a JTAGjet connected to the target STRx on your application board
via either a JTAG or an ETM connector.
Then, configure the tool using the "Advanced Options.", either under the ARM RLink section or
under the JTAGJet section according to the chosen debugging tool: