User manual
Table Of Contents
- 1. Introduction
- 2. Raisonance tools for ARM overview
- 3. How to register the new Raisonance tools for ARM
- 4. Creating a project
- 5. Debugging with the simulator
- 6. Debugging with hardware tools
- 6.1 Selecting hardware debugging tools
- 6.2 RLink-ARM programming and debugging features
- 6.3 JTAGjet programming and debugging features
- 6.4 Cortex Serial Wire Viewer (SWV) debugging features (Open4 RLink only)
- 6.4.1 Introduction
- 6.4.2 Hardware requirements
- 6.4.3 Configure Ride7 to use the SWV
- 6.4.4 Modify your application to use SWV software traces
- 6.4.5 Configure Ride7 to use SWV software traces
- 6.4.6 Configuring Ride7 to use the SWV hardware traces
- 6.4.7 Configuring Ride7 to use the SWV watchpoint traces
- 6.4.8 Start / Stop the trace
- 6.4.9 Visualizing SWV traces with Ride7
- 7. Raisonance solutions for ARM upgrades
- 8. Conformity
- 9. Glossary
- 10. Index
- 11. History
Raisonance Tools for ARM 1. Introduction
1. Introduction
This guide should be used by anyone with an interest in Ride7 for ARM.
The new Ride7 and RKit-ARM must be registered to operate correctly.
1.1 Purpose of this manual
This manual helps you get started using any of the Raisonance products that are offered by
Raisonance’s application development solution for ARM core-based MCUs. It describes how to
compile and debug your application or one of the included sample applications. It assumes that you
have the prerequisite knowledge of the C and ARM / thumb / thumb2 assembly languages and CPUs.
1.2 Scope of this manual
The tools specifically addressed in this manual include:
• GCC C compiler toolchain
• Ride7 development environment
• RFlasher7 programming interface
• RLink debugger programmer
1.3 Related documents
Each tool in this document has its own user manual. These documents are provided with the
Raisonance software installation and in the support section of the Raisonance internet site www.mcu-
raisonance.com.
• RLink user manual
• Using the Open4 (EvoPrimer) user manual
• REva v3 user manual
• REva v2 and earlier user manual
• REva STM32 daughter boards user manual
• REva STRx daughter boards user manual
• Ride7 Online help (provided with installation)
• RFlasher7 user manual
• GCC toolchain user documentation (provided with installation)
1.4 Additional help or information
Please visit the Raisonance website: http://www.raisonance.com/ and the forum
http://www.raisonance.com/Forum/punbb/ or contact Raisonance.
Address: Raisonance S.A.S.
17, Avenue Jean Kuntzmann,
38330 Montbonnot Saint Martin
France
Telephone: +33 4 76 61 02 30
Fax: +33 4 76 41 81 68
Email: support@raisonance.com
If you find any errors or omissions, or if you have suggestions for improving this manual, please let us
know by email.
- 5 -