User manual
Table Of Contents
- 1. Introduction
- 2. Raisonance tools for ARM overview
- 3. How to register the new Raisonance tools for ARM
- 4. Creating a project
- 5. Debugging with the simulator
- 6. Debugging with hardware tools
- 6.1 Selecting hardware debugging tools
- 6.2 RLink-ARM programming and debugging features
- 6.3 JTAGjet programming and debugging features
- 6.4 Cortex Serial Wire Viewer (SWV) debugging features (Open4 RLink only)
- 6.4.1 Introduction
- 6.4.2 Hardware requirements
- 6.4.3 Configure Ride7 to use the SWV
- 6.4.4 Modify your application to use SWV software traces
- 6.4.5 Configure Ride7 to use SWV software traces
- 6.4.6 Configuring Ride7 to use the SWV hardware traces
- 6.4.7 Configuring Ride7 to use the SWV watchpoint traces
- 6.4.8 Start / Stop the trace
- 6.4.9 Visualizing SWV traces with Ride7
- 7. Raisonance solutions for ARM upgrades
- 8. Conformity
- 9. Glossary
- 10. Index
- 11. History
6. Debugging with hardware tools Raisonance Tools for ARM
6.4.8 Start / Stop the trace
The Start / Stop command is available on the SWV Global Trace View.
1. Click on Debug->Advanced commands...->SWV Global Trace View .
2. Click on Start Trace to start the trace acquisition.
3. Click on Suspend Trace to stop the trace acquisition.
4. Click on Start Trace again to continue trace acquisition: the new events are appended after the
existing trace.
5. Click on Restart Trace to start a new trace acquisition: the trace is reinitialized (views and
buffers are cleared) and the previous trace is lost.
- 38 -