User manual

Raisonance Tools for ARM
4.4.2 LD linker options..................................................................................................................... 17
5. DEBUGGING WITH THE SIMULATOR..........................................................................20
5.1 About the simulator........................................................................................................................ 20
5.2 Simulator options........................................................................................................................... 20
5.3 Launching the simulator................................................................................................................. 20
5.4 Simulator toolbar............................................................................................................................ 22
5.5 Viewing a peripheral...................................................................................................................... 23
5.6 Viewing the stack........................................................................................................................... 23
5.7 Using breakpoints.......................................................................................................................... 24
6. DEBUGGING WITH HARDWARE TOOLS.....................................................................25
6.1 Selecting hardware debugging tools..............................................................................................25
6.2 RLink-ARM programming and debugging features........................................................................26
6.2.1 RLink capabilities.................................................................................................................... 26
6.2.2 Configuring Ride7 for using the RLink....................................................................................27
6.2.3 Hints and troubleshooting.......................................................................................................30
6.3 JTAGjet programming and debugging features.............................................................................30
6.3.1 Signum Systems USB driver installation.................................................................................30
6.3.2 Installing the Signum Systems USB driver for Ride7..............................................................31
6.3.3 Installing the RDI driver for third party debuggers...................................................................31
6.3.4 Using the JTAGJet/STR9 trace features (ETM) in Ride7........................................................31
6.4 Cortex Serial Wire Viewer (SWV) debugging features (Open4 RLink only)...................................32
6.4.1 Introduction............................................................................................................................. 32
6.4.2 Hardware requirements..........................................................................................................32
6.4.3 Configure Ride7 to use the SWV............................................................................................32
6.4.4 Modify your application to use SWV software traces..............................................................33
6.4.5 Configure Ride7 to use SWV software traces.........................................................................34
6.4.6 Configuring Ride7 to use the SWV hardware traces...............................................................34
6.4.7 Configuring Ride7 to use the SWV watchpoint traces.............................................................36
6.4.8 Start / Stop the trace............................................................................................................... 38
6.4.9 Visualizing SWV traces with Ride7.........................................................................................39
7. RAISONANCE SOLUTIONS FOR ARM UPGRADES....................................................42
7.1 Hardware upgrade paths 1a and 1b (RLink-STD to RLink-PRO)...................................................42
7.2 Upgrade path 2 (RKit-ARM-Lite to RKit-ARM-Enterprise)..............................................................43
7.3 RKit and RLink options.................................................................................................................. 43
- 3 -