User manual
Table Of Contents
- 1. Introduction
- 2. Raisonance tools for ARM overview
- 3. How to register the new Raisonance tools for ARM
- 4. Creating a project
- 5. Debugging with the simulator
- 6. Debugging with hardware tools
- 6.1 Selecting hardware debugging tools
- 6.2 RLink-ARM programming and debugging features
- 6.3 JTAGjet programming and debugging features
- 6.4 Cortex Serial Wire Viewer (SWV) debugging features (Open4 RLink only)
- 6.4.1 Introduction
- 6.4.2 Hardware requirements
- 6.4.3 Configure Ride7 to use the SWV
- 6.4.4 Modify your application to use SWV software traces
- 6.4.5 Configure Ride7 to use SWV software traces
- 6.4.6 Configuring Ride7 to use the SWV hardware traces
- 6.4.7 Configuring Ride7 to use the SWV watchpoint traces
- 6.4.8 Start / Stop the trace
- 6.4.9 Visualizing SWV traces with Ride7
- 7. Raisonance solutions for ARM upgrades
- 8. Conformity
- 9. Glossary
- 10. Index
- 11. History
6. Debugging with hardware tools Raisonance Tools for ARM
6.2.2.2 RLink JTAG-SWD ADP jumpers
When using a stand-alone RLink, you must use an ADP to adapt the RLink’s 24-pins connector to the
target connector. If using JTAG-ARM ADP, there is no configuration to perform. If using JTAG-SWD
ADP, you must plug two jumpers on the left side, as shown in the picture (default factory setting).
Note: SWD is supported by this version of the software. There is no need to change the jumpers
position, keep them in the positions shown in this picture. (JTAG) As the SWD connector is a subset of
the JTAG connector, you can also use the SWD protocol with the older JTAG-ARM ADPs, and also with
all versions of the REva board.
- 28 -