User manual
Table Of Contents
- 1. Introduction
- 2. Raisonance tools for ARM overview
- 3. How to register the new Raisonance tools for ARM
- 4. Creating a project
- 5. Debugging with the simulator
- 6. Debugging with hardware tools
- 6.1 Selecting hardware debugging tools
- 6.2 RLink-ARM programming and debugging features
- 6.3 JTAGjet programming and debugging features
- 6.4 Cortex Serial Wire Viewer (SWV) debugging features (Open4 RLink only)
- 6.4.1 Introduction
- 6.4.2 Hardware requirements
- 6.4.3 Configure Ride7 to use the SWV
- 6.4.4 Modify your application to use SWV software traces
- 6.4.5 Configure Ride7 to use SWV software traces
- 6.4.6 Configuring Ride7 to use the SWV hardware traces
- 6.4.7 Configuring Ride7 to use the SWV watchpoint traces
- 6.4.8 Start / Stop the trace
- 6.4.9 Visualizing SWV traces with Ride7
- 7. Raisonance solutions for ARM upgrades
- 8. Conformity
- 9. Glossary
- 10. Index
- 11. History
3. How to register the new Raisonance tools for ARM Raisonance Tools for ARM
8. Check your server for an email from Raisonance Support team with the Activation Code.
9. Copy the Activation Code from the email to the Ride7 window. Click Finish.
10. Close Ride7 and open it again. Check in the About Ride7 window that you are in "Lite Suite" for
RKit-ARM and "Standard version" for Ride7. Otherwise please contact our technical support
(support@raisonance.com).
3.3 Register using a dongle
1. Plug in the dongle and make sure the LED lights up (otherwise you must install the driver).
2. Open Ride7 or RFlasher7. If it does not open automatically click Help->About Ride7.
3. Click the Change License button. Select Dongle Activation, click Next.
4. Close Ride7 and open it again. Check in the About Ride7 window that you are in "Lite Suite" for
RKit-ARM and "Standard version" for Ride7, otherwise contact our technical support
(support@raisonance.com).
3.4 Register using an RLink
Automatic registration can be performed using an RLink-STD, RLink-PRO, REva starter kit or Primer.
Automatic registration requires that you have the PC connected to the internet and a hardware serial
number, or software serial key that is covered by a valid support contract.
Follow these steps to register your RLink automatically:
1. Log on as admin, ensure you have internet access, a working default browser and a working
email address.
2. Plug in the RLink and make sure the BUSY LED turns OFF (USB enumeration).
3. Open Ride7 or RFlasher7. If it does not open automatically click Help->About Ride7.
4. Click the Change License button. Select RLink Activation, click Next.
5. If the software finds the RLink, it says RLink detected. Ready for registration. Click Next.
6. Connect to the internet and click Get Activation code online to open your browser on the
Raisonance server.
7. Fill in the form and click Generate and Send Activation code.
8. Check your server for an email from Raisonance Support team with the Activation Code.
9. Copy the Activation Code from the email to the Ride7 window. Click Finish.
10. Close Ride7 and open it again. Check in the About Ride7 window that you are in "Lite Suite" for
RKit-ARM and "Standard version" for Ride7. Otherwise please contact our technical support
(support@raisonance.com).
- 10 -