User manual

Raisecom Technology Co., Ltd
5
z Only support framed E1 (PCM31, FAS+CRC4 by default), CRC auto-negotiation
and is configurable
z There are four status indicators for each E1 circuit:
 LOS: Loss of Signal (local)
 PAT: indicator for BERT
 LER: local E1 general alarm, including AIS(alarm indication signal),
LOF( Loss of Frame), CRC(Cyclic Redundancy Check)
 RAL: remote E1 alarm, including LOS, AIS, LOF, CRC
z Local and remote E1 loop back
z E1 BERT (bit error rate tester) function
z The DIP-switch on the front panel is for the following functions’ configuration
 Master and slave management
 Enable and disable loop back
 Local and remote E1 loop back
 BERT function
 Auto negotiation, speed and duplex configuration of Ethernet interface
 Clock mode configuration
z Remote manageable by RC953-8FE16E1
3.4. Power supply
z Voltage range: -48VDC, –36V - -72V
220VAC, 90V- 264V
z Power consumption: <10W
3.5. Ambience
z Temperature: -5℃-50℃
z Relative Humidity: ≤90%(35℃)