User manual

Raisecom Technology Co., Ltd

6.2.3. Connect the fast Ethernet interface

For electrical Ethernet interface: connect one end of the Cat. 5 UTP cable with Ethernet

router/switch and one end of the cable with the fast electrical Ethernet port of RC953. The

LNK indicator will be ON after correct connection.

For optical Ethernet interface: connect one end of the fiber with optical router/switch and

the other end with the optical Ethernet interface of RC953.

6.2.4. Connect the E1 cable

For unbalanced E1 equipment: use 75ohm unbalanced BNC cable.

For balanced E1 equipment: use 120ohm balanced RJ-45 cable.

6.2.5. Power on

If power supply is DC –48V, first connect middle end to PGND. Turn off Power Supply,

connect “-48V” end with the lower electric level cable, “0V” end with higher electric level

cable. Make sure no reverse connection, or no short circuited, and then turn on power.

When Power Supply is turned on, the PWR indicator should be ON.

6.2.6. Service configuration

Please refer to the command notebook and configuration guide of RC953-8FE16E1 for

the service configuration.