User manual
Raisecom Technology Co., Ltd
13
6. Installation & preparation
6.1. Preparation before Installation
Please check if the models and part numbers are in consistence first, and also check if the
equipments are damaged. There must be drying process if the equipment is damped.
Please follow the following steps when install and use this equipment:
z Carefully read this manual
z Fix and install the equipment
z Connect E1 cable and Ethernet cable
z Configure the equipment according to the configuration guide
z Use the equipment correctly
6.2. Installation
6.2.1. Cable preparation
The following cables need to be prepared:
Table 6-1 Cable specification for RC953 connectors
Connector Cable specification
10/100Mbps Electrical
Ethernet connector
(SNMP management
connector)
Cat. 5 100Base-T UTP, and the maximum
length is 100m (prepared by customers)
Optical fiber for SC
connector
Please prepare the optical fiber for different types
of optical fiber connectors (prepared by
customers)
75ohm unbalanced
BNC cable
Prepared by customers
120ohm balanced
RJ45 cable
Prepared by customers
Power supply
connector
AC power supply: provide one AC power supply
cable.
DC power supply: provide one DC power supply
cable.
6.2.2. Set the DIP-switch
Please set the DIP-switch according to your requirements, refer to table 4-1for DIP-switch
definition.