User manual

Raisecom Technology Co., Ltd
14
Receive Timing (B) — RCK(B) O X
Send Data (A) — TD(A) I P
Send Data (B) — TD(B) I S
Send Timing (A) — TCK(A) O Y
Send Timing (B) — TCK(B) O AA
Terminal Timing (A) — SCTE(A) I U
Terminal Timing (B) — SCTE(B) I W
Request to Send — RTS I C
Clear to Send — CTS O D
Data Set Ready — DSR O E
Data Carrier Detect — DCD O F
Data Terminal Ready — DTR I H
4.3. Dip-switch on the bottom
There are seven group eight-bit dip-switches that are SW1,
SW2, SW3, SW4, SW5, SW6 and SW7 on the bottom of the
device. The configuring of these dip-switches must be
performed before power on! If the switches are configured
during running status, the device must be restarted to make the configuration
effective. Each dip-switch is shown as the left figure. The DOWN indicates OFF and UP
indicates ON when from left to right the bit is 1
st
to 8
th
. There is also a note pasted on the
bottom of the device as the following figure:
Configuration Note on the device bottom
S
W1 SW2 SW3 SW4 SW5 SW6
O
ptic
Port
V
.35 Port
Power
Interface
Power
Switch
E
1
P
ort
SW7
1 2 3 4 5 6 7 8
ON DIP
OFF
ON