User manual

ENGLISH RAIS - Manual for RONDO & MINO II

Adjustment of chimney connection

The stove is always delivered for top connection, but can be changed to rear connection

as follows:

Remove bae plate and

smoke diverter (see clean-

ing and care).

Loosen the 3 M6 nuts with a wrench key.

Make sure that the ue

diverter is fastened to the

protective cover.

Lift up the reector plate, push out the knock-out,

and put the reector plate back into place.

Remove the casing knock-out.

Remove protective cover and seal and place over the

hole on the top - make sure that the seal is positioned

properly. Tighten the assembly using the 3 M6 nuts.

The ue outlet spigot, which you will nd in a pouch

in the stove, and the holder for the upper ue diverter

are assembled with 3 M6x20 head cap screws and M6

nuts.

The upper ue diverter, bae plate and top plate are

assembled in reverse order.