User manual

ENGLISH RAIS - Manual for RONDO & MINO II

Normal set-up (right-angled) secure base

A. Distance to furniture 1050 mm

Distance to ammable materials:

B. - in front (oor) 300 mm

C. - to the side (oor) 150 mm

D. - Rondo rear (wall) 100 mm

D. - Mino II rear (wall) 150 mm

E. - to the side of the wall 500 mm

Corner set-up 45°

A. Distance to furniture 1050 mm

Distance to ammable materials:

B. - in front (oor) 300 mm

C. - to the side (oor) 150 mm

D. - Rondo rear (wall) 100 mm

D. - Mino II rear (wall) 150 mm

E. - to the side of the wall 500 mm

Installation distance in case of non-

combustible wall

We recommend a minimum distance to

non-combustible material of 50mm(F) for

cleaning considerations.

It should always be possible to access the

clean-out door.

360° swivel base - normally placed as a

room divider

A. Distance to furniture 1050 mm

Distance to ammable materials:

B. - in front (oor) 300 mm

Installation distance in case of combustible wall

To nd out whether the wall next to where the stove is going to be installed is ammable,

you should contact your building contractor or the local building authorities.

The hearth should be able to accommodate the weight of the stove. The chimney must

be independently supported by wall brackets or a ceiling support plate. The weight of the

stove is indicated in the brochure.

The stove should always be installed on a non-combustible hearth of a size and construc-

tion that is in accordance with the provisions of the current UK Building Regulations Ap-

proved Document J.

If the stove is to be installed on a wooden oor, it must be covered with a noncombustible

material at least 12mm thick, in accordance with UK Building Regulations Approved Docu-

ment J, to a distance of 300 mm in front of the stove and 150 mm to each side measuring

from the door of the combustion chamber.

The clearance distances to combustible material beneath, surrounding or upon the hearth

and walls adjacent to the hearth should comply with the guidance on the separation of

combustible material given in UK Building Regulations Approved Document J and also in

these stove instructions.