Installation Guide

Wall
Outside The Wall
≥25mm
0.98inch
The Procedure Of Sealing The Wall
Use a parallel ruler to measure the flatness of the embedded box casing and
the vertical wall surface.If the wall surface is not flat, it should be patched
to ensure the embedded box casing and vertical wall angle meets at nearly
ideal angle of 90, then lay the tile decoration.
Shower Head Installation
1.Wrap the tape around the pipe thread and screw it on the wall hole
2.Screw the head shower onto the outlet pipe thread
Tile or wooden surface
Model: 96203-10/12
Installation Instruction 3/3
1.Take off the protective cover
2. The panel and the handle are
connected to the control valve
as shown below sequence
Installation of Rough-in Valve Handle Shower Installation
1. Take off the two screws in the bottom of the shower holder.
2. Wrap the tape around the pipe thread and screw the seat on the wall hole
3. Screw the two screws on again
4. Screw the handheld shower and hose onto the holder.
Tub Spout Installation
1.Take off the two screws in the bottom of the tub spout.
2.Wrap the tape around pipe thread, screw the tub spout on wall hole.
3.Screw the two screws on again.
21