Installation Guide

Pipe Connection
1.Please drill the holes on the wall for the main body embedded part,
hot and cold water inlet pipes as well as shower arm connection
pipes according to the basic product dimension drawing as below.
2.Please make hot and cold water inlet pipe, the mixed water outlet
pipe connect with control valve, and tighted with the wrench.
Cold water
Hot water
Head shower
Bathtub spout
Hand shower
Tile surface
wall
Max.80mm
3.15inch
Min.60mm
2.36inch
1.The size of the embedded box
that needs to be drilled is 5.7 ” * 6.7”
2.The depth of the embedded box is 2.36 ” - 3.15”
It's better to drill the depth of 2.36''for blank wall
Model: 96203-10/12
Installation Instruction 2/3
Hot Water
Cold Water
Mixer Water
Mixer Water
Mixer Water
170mm
6.7inch
130mm
5.12inch
145mm
5.7inch
50mm
1.97inch
Water Testing And Sealing Testing
1.After the pipeline connection is completed, unscrew the stop valve, open
the pipeline switch to flush the impurities and sludge to avoid blockage and
affect the water flow function;
2.Close the switch, re-tighten the stop valve and open the switch again to
make the pipeline is under pressure. Check the pressure resistance and
sealing performance of the valve and pipeline to ensure that there is no
leakage in the pipeline.
20