Installation Guide

Wall
Outside the wall
≥25mm
0.98inch
The Procedure of Sealing The Wall
Use a parallel ruler to measure the flatness of the embedded box casing
and the vertical wall surface.If the wall surface is not flat, it should be
patched to ensure the embedded box casing and vertical wall angle meets
at nearly ideal angle of 90, then lay the tile decoration.
Handle Shower Installation
Tile or wooden surface
Head Shower Installation
1.Wrap the tape around the pipe thread and screw it on the wall hole
2.Screw the head shower onto the outlet pipe thread
Shower Holder Installation
1. Take off the two screws in the bottom of the shower seat.
2. Wrap the tape around the pipe thread and screw the seat on the wall hole
3. Screw the two screws on again
1.Take off the protective cover
2. The panel and the handle are
connected to the control valve
as shown below sequence
Installation of Rough-in Valve
Model: 96202-10/12
Installation Instruction 3/3
12