Installation Guide
Table Of Contents
Tile or wooden surface
Wall
Outside the wall
≥25mm
0.98inch
The Procedure of Sealing The Wall
Use a parallel ruler to measure the flatness of the embedded box casing and the vertical wall surface. If the wall surface is not flat, it should be patched
to ensure the embedded box casing and vertical wall angle meets at nearly ideal angle of 90, then lay the tile decoration.
Head Shower Installation
2. The panel and the handle are connected to
the control valve as shown below sequence
H
C
1.Take off the protective cover
Installation Of Rough-in Valve
1.Wrap the tape around the pipe thread
and screw it on the wall hole
2.Screw the head shower onto the outlet
pipe thread
Model: 96201-10/12
Installation Instruction 3/3
9