Installation Guide

Model: 95102-10/12
Installation Instruction 3/3
Cold water
Hot water
Head shower
Bathtub spout
1.Cut away the part of the embedded box
sticking out so that it is parallel with the wall.
Water Testing And Sealing Testing
1.After the pipeline connection is completed, tighten the plug, open the switch to make the pipeline is
under pressure. Check the pressure resistance and sealing performance of the valve and pipeline to
ensure that there is no leakage in the pipeline.
2.Close the switch, unscrew the plug to flush the impurities and sludge to avoid blockage and affect
the water flow function;Make sure there is no problem with the pipeline. It can be connected to the
head shower, hand-hold and the tub spout.
3.The panel and the handle are connected to
the control valve .
Shower Head Installation
1.Wrap the tape around the pipe thread and
screw it on the wall hole.
2.Screw the head shower onto the outlet pipe
thread.
Handle Shower Installation
1. Take off the two screws in the bottom of
the shower holder.
2. Wrap the tape around the pipe thread and
screw the seat on the wall hole.
3. Screw the two screws on again.
4. Screw the handheld shower and hose onto
the holder.
24