Installation Guide

1.Cut away the part of the
embedded box sticking out so
that it is parallel with the wall.
3.The panel and the handle are
connected to the control valve .
Model: 97203-10/12
Installation Instruction 3/3
Cold water
Hot water
Head shower
Bathtub spout
Hand shower
12
Shower Head Installation
1.Wrap the tape around the pipe
thread and screw it on the wall
hole.
2.Screw the head shower onto
the outlet pipe thread.
Handle Shower Installation
1. Take off the two screws in the
bottom of the shower holder.
2. Wrap the tape around the pipe
thread and screw the seat on the
wall hole.
3. Screw the two screws on again.
4. Screw the handheld shower
and hose onto the holder.
Tub Spout Installation
1. Take off the two screws in the
bottom of the tub spout.
2. Wrap the tape around the pipe
thread and screw the tub spout
on the wall hole.
3. Screw the two screws on again.
Water Testing And Sealing Testing
1.After the pipeline connection is completed, tighten the plug, open the switch to make the pipeline is
under pressure. Check the pressure resistance and sealing performance of the valve and pipeline to
ensure that there is no leakage in the pipeline.
2.Close the switch, unscrew the plug to flush the impurities and sludge to avoid blockage and affect
the water flow function;Make sure there is no problem with the pipeline. It can be connected to the
head shower, hand-hold and the tub spout.