Installation Guide

Model: 8010
Installation Instruction 3/3
4
6
3
G1/2
5
8
6.Connect one end of the shower hose (#7 ) to the
mixer (#2) and the other end to the handle shower
(#9). Ensure the washer is placed into each end for
seal.
4
3
4
3
9
7
1
18
2
4.Mark the locations for the screws with a pencil. With an electric drill, drill four holes for the expansion screws
(#8) in the floor. Place the expansion screw (#8) into the holes. Connect the flexible supply lines (#5) to the
water supplies.
5.Ensure the standing pipe (#3) sits flush against the
finished floor surface. Then secure the standing pipe
(#3) using screws (#8). Push the escutcheon (#4) over
the standing pipe (#3) base so that it sits flush against
the finished floor surface.