Installation guide

Chapter 7: Understanding FlashCONNECT Java Components
84 FlashCONNECT Administrator’s Guide
To reconfigure setup parameters:
Click Reconfigure from the FCServlet Diagnostic dialog box. The FCServlet
Diagnostic Configuration box displays.
3. Change any of the parameters, then click OK.
Resetting the Test Selection
You can clear the FCServlet Diagnostic dialog box and reselect the tests to perform.
To clear the FCServlet Diagnostic dialog box and select new tests:
1. Click Reset in the FCServlet Diagnostic dialog box.
The test check boxes and the data in the comments section are cleared.
2. Select any of the check boxes next to the tests that you want to perform.
3. Click Run Check.
Viewing Information about the FCServlet Diagnostic
Application
You can display the current version and copyright information.
To display version and copyright information:
• In the FCServlet Diagnostic dialog box, click About.