Installation guide

Accessing the FlashCONNECT Socket Server Manager
FlashCONNECT Administrator’s Guide 61
Starting the FlashCONNECT Socket Server Manager
Manually
This procedure starts the FlashCONNECT Socket Server Manager and the port that
you set in the configuration.
Windows:
1. Open the MS-DOS Window.
2. Type:
FCSocketServer -start
3. Press Enter.
The FlashCONNECT Socket Server Manager dialog box displays.
UNIX:
To run the FlashCONNECT Socket Server Manager graphical user interface, X
Windows must be installed. Otherwise, you can only start and stop the
FlashCONNECT Socket Servers from these commands:
.\fcsocketserver start
.\fcsocketserver stop
Without a GUI, you cannot take advantage of viewing log entries, adding additional
FlashCONNECT Socket Server ports or running FlashCONNECT Servlet diagnostic
tests.
To start the FlashCONNECT Socket Server Manager:
• At the prompt, type:
fcsocketserver start {port {gui}}
Where port indicates the socket server port number (1-65535) and gui
indicates that X Windows is installed.
The message Starting FlashCONNECT Socket Server displays.
The FlashCONNECT Socket Server Manager interface displays.