Installation guide

Appendix B: Debugging and Diagnosing FlashCONNECT Configuration
138 FlashCONNECT Administrator’s Guide
Diagnosing FlashCONNECT Configuration
Problems (D3 Only)
The checkup program examines the overall FlashCONNECT configuration and checks
for potential and fatal problems. The checkup program does not change the D3 or
FlashCONNECT configuration.
There are two ways to run the diagnostic:
• From TCL type:
run bp checkup
• From the TCL FlashCONNECT Main Menu, select 7. Diagnostics, then select 1.
Run the Online Diagnostics.
When the checkup program starts, the following screen displays:
If Q is entered, the program stops without performing any checks.
This program performs simple checks to uncover problems which
commonly cause FlashCONNECT to not work. This program displays as a
series of questions and answers. Other than starting this program the
user does not enter any information.
Problems which will probably cause FlashCONNECT to not work or not
work with a specific host are labeled 'FATAL'.
Problems which might cause problems while FlashCONNECT is running are
marked, 'NO'.
Tests which pass are marked with 'YES'.
These tests run in a few seconds, do not change the FlashCONNECT
configuration and can be used on a running FlashCONNECT system.
See the FlashCONNECT documentation for more information about each
test.
Press 'Q' to quit or 'Enter' to continue?