Installation guide

Chapter 9: Customizing the FlashCONNECT Server and Web Server
100 FlashCONNECT Administrator’s Guide
w3_Can’t Open Socket Unable to open Socket
(errno=XXX)
An error occurred when using the host
operating system. The number shown is the
error code returned by the host operating
system. See Error Messages
and refer to the
FlashCONNECT FAQs
section of the Raining
Data Web site.
w3_BadActivation Product must be
activated before it can
be used
FlashCONNECT cannot be activated. Use the
sysid command to verify whether
FlashCONNECT is activated.
• If FlashCONNECT is not available, you need
a temporary activation.
• If you purchased FlashCONNECT, reactivate
the D3 System.
w3_BadActivationMask Activation Mask Invalid This version of FlashCONNECT is not supported
on this platform. Verify that the database
server and FlashCONNECT are compatible.
w3_BadClientRead Read did not complete The D3 active server received an error while
reading a submitted form, or this
FlashCONNECT line is being shutdown.
w3_NoUsersAvailable No D3 licenses
available
There were not enough D3 user licenses
available to start another FlashCONNECT
connection. To correct, do one of these:
• Free up D3 user licenses being used for
other purposes.
• Purchase more D3 user licenses.
• Configure fewer concurrent FlashCONNECT
connections.
w3_ProcessingRequest Processing Common status for a FlashCONNECT
connection indicating that FlashCONNECT is
running an application and it is not waiting for
a message from FCService. While in this state,
the FlashCONNECT connection does not
respond to the WWW-STOP or WWW-MANAGER
STOP commands. However, it should respond
to a WWW-STOP (F command and it will
respond to the WWW-STOP and WWW-MANAGER
STOP commands when the request being
processed has completed and the connection
is ready for the next request.
Message Name Message Meaning and Suggestions