Installation guide

Chapter 9: Customizing the FlashCONNECT Server and Web Server
98 FlashCONNECT Administrator’s Guide
The second line of each entry (or 3rd line in D3) contains the same information that
displays if you were to run the where command from TCL. We use the where
command elements to describe the information presented. Refer to the D3
Reference Manual for additional detail on the where command.
The table below describes each element in line 2 of WWW-STATUS.
Explanation of WWW-STATUS and w3Lines Status
Messages
This section describes in detail the messages shown in the w3Lines file and by the
WWW-STATUS command.
Status Status of the line.
Input: waiting for input.
Processing: processing a FlashCONNECT application.
Socket: waiting to connect to the Web server.
Other: copy the w3Lines item to the screen to see the full text.
To see the complete message, enter:
ct w3lines
See Explanation of
WWW-STATUS and w3Lines Status Messages for
more information.
Time/Date Time and date of the last time the line was used.
Application Application that is running as defined in w3Apps.
Element Description
Line Port issuing the command.
PCB FID Frame-ID of the primary control block.
PIB Stat PIB status of the port.
ABS base Beginning FID of the ABS currently being executed
by the port.
Stat Current status of the port.
R1 & Return stack contents ABS mode currently executing on the port.
NOTE—The numeric message value as found in the w3Include item (for example,
EQU w3_OK TO 0) and message text as found in the w3Messages and
Messages files may change without notice.
Element Description