Installation Guide

866-905-7625 | [e-mail] | Raingler.com
Step 1
Remove and/or
loosen upper trim
panel in the front
and rear. You will
need to remove
the factory grab
handle from front
and rear on
passenger side
using the Torx
driver. Flip the
plastic cover back on each size to access. Driver’s side only has a
rear handle to remove. Pop back pillar panel a bit to allow room to work.
Step 2
Locate the best
area to install the
hardware. Just a
little in front or behind
peg hold for the
panel works well.
Mark your hole
with the Sharpie
pen before drilling.
(Use peg on back
of trim you
removed and stick
it in the top of the seatbelt harness area as shown below to keep it out of your way). Drill hole.
We have installed this mount in two locations for different applications. For shorter people and to always
keep seats forward, drill your holds in FRONT of the peg hold for the panel. If you like your seats pushed back
all the way, then we suggest drilling the hole further back. See photo for reference.
O
O
toward front
toward rear
.