Installation Guide

ManualsBrandsRaingler NETS GRIPS ManualsCherokeeRaingler NETS GRIPS XJ Behind Front Seat Barrier Jeep Cherokee

Behind front seat barrier Jeep Cherokee XJ

shown on 2000-year model

NOTE: Many newer models have B-pillar handles and even overhead on the ceiling that can be used for some of the top

mounting locations. Check to see if you prefer to use these factory locations as the nets typically have enough adjustment

to allow for this option. If your vehicle does not have handles in desired locations or you prefer to install mounting points for

better fitment, please follow the below steps.

IMPORTANT: READ INSTRUCTIONS FULLY BEFORE STARTING

Time:

45 – 60 minutes

Paw Level:

Tools:

1. Drill

2. Bit slightly smaller than #12 screw

3. a 5/64 or similar Phillips Head Screwdriver or

PH2 Bit

4. Torx 20 bit or driver

5. Sharpie

6. Something to trim plastic, like snips or knife

Summary of content (5 pages)

PAGE 1
Behind front seat barrier Jeep Cherokee XJ shown on 2000-year model NOTE: Many newer models have B-pillar handles and even overhead on the ceiling that can be used for some of the top mounting locations. Check to see if you prefer to use these factory locations as the nets typically have enough adjustment to allow for this option. If your vehicle does not have handles in desired locations or you prefer to install mounting points for better fitment, please follow the below steps.
PAGE 2
Step 1 Remove and/or loosen upper trim panel in the front and rear. You will need to remove the factory grab handle from front and rear on passenger side using the Torx driver. Flip the plastic cover back on each size to access. Driver’s side only has a rear handle to remove. Pop back pillar panel a bit to allow room to work. Step 2 toward front O O. Locate the best area to install the hardware. Just a little in front or behind peg hold for the panel works well.
PAGE 3
Step 3 Install hardware Step 4 Reassemble front and rear upper trim, handles. Make sure that ring sticks fully out of the top of the panel. Step 5 Repeat for Driver’s side. Note that driver’s side doesn’t have a front grab handle. You may want to cut out the right front area of the center pillar for easier access when drilling. . Step 6 Reassemble driver’s side panels. Make sure your hardware is hanging over the top. 866-905-7625 | Tech@RAINGLER.com | Raingler.com .
PAGE 4
Step 7 Loosely install the net on top mounts Step 8 Loosely install the net on bottom by attaching to seat brackets. This will not affect your seat sliding back and forth. 866-905-7625 | Tech@RAINGLER.com | Raingler.
PAGE 5
Step 9 Do a final adjusting and checking seat positioning and wrap and tuck all excess ends. To see how to wrap and tuck up the excess strap visit our Raingler channel. https://vimeo.com/raingler Check out the video here on YouTube: https://vimeo.com/raingler Thank you for purchasing Raingler Nets. If you have any questions please contact us, we are here to help! 866-905-7625 | Tech@RAINGLER.com | Raingler.