Installation Guide

866-905-7625 | [e-mail] | Raingler.com
If your B pillar looks like this with the red nylon push in
piece:
You may remove the red piece of you have a panel removal
tool to make installation easier to access and slide back on
the plastic panel in the slotted hole.
It is suggested to use a 13/64” drill bit to do final hole
finishing on B Pillar.
It’s three layers of metal so slide the footman mount out of
the tether and place exactly as shown here:
Double check your depth before and during drilling to
mount.
Pro tip: tap the holes in the footman so that your drill bit
does not wander. Use a little oil on the drill bit to help it cut
through the layers of metal.
Once the holes will accommodate the screws threads, treat
the metal with some paint. *Clear nail polish will work well
in a pinch.