EAGLE™ Quick Start Guide EAGLE™ Energy Access Gateway Link to Ethernet Texas Quick Start Guide Rainforest EAGLE™ Information Label (found on the underside of the device) MAC Address Install Code Local Web Address Cloud ID Contents: 1. Setup 2. Connect to Bidgely 3. FCC Notices www.swesmarts.
EAGLE™ Quick Start 1. Setup Step 1: Prerequisite software and hardware 1) Access to an Ethernet connection directly connected to the Internet, e.g router. 2) A PC or other device with a web browser and an internet connection (for access to cloud service). Step 2: Register your EAGLE™ If you purchased the Pre-Provisioning Service from Southwest Energy Smarts proceed directly to Step 3. • Set up an account at http://www.smartmetertexas.
EAGLE™ Quick Start Guide Note: The computer running the web browser must be connected to the same router as the EAGLE™, and the computer must also be running multicast Domain Name System (mDNS), which is known as Bonjour on Apple computers. mDNS may be already installed on your computer, as many printers and Apple’s iTunes use this protocol. If you need to manually install mDNS on your Windows PC, you can find instructions at: http://support.apple.com/kb/DL999.
EAGLE™ Quick Start 2. Connecting to Bidgely Step 1: Set up the EAGLE™ upload server 1) From the Web Viewer home page, click on the “CONFIG” button in the upper left corner to get to the “Basic Configuration” page. 2) Click on the “CONFIG CLOUD” button to get to the “Cloud Configuration” page. 3) Select “Bidgely” from the drop-down menu for “Set Upload Host”. 4) Click the “Register new account” button. 1 2 3 4 Step 2: Get a Bidgely account 1) Open another window in your web browser and go to bidgely.com.
EAGLE™ Quick Start Guide 4 5 6 4) Select “Rainforest EAGLE (RFA-Z109)” 5) In the “Cloud ID/INET” field, enter: the 6-digit Cloud ID found on the Information Label on the underside of the EAGLE™. 6) Click “Update Info” 7) You will see a dialog box appear that asks you to test your connection. Click “OK”. Notice that a “Test Connection” button appears at the bottom of the page. 8) Click the “Test Connection” button.
EAGLE™ Quick Start FCC/IC Notices This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the manufacturer could void the user’s authority to operate the equipment.
