Manual

14
U3745BM
4663A–RKE–06/03
T
Lim_min
= Lim_min ´ T
XClk
T
Lim_max
= (Lim_max –1) ´ T
XClk
Lim_min and Lim_max are defined by a 5-bit word each within the LIMIT register.
Using the above formulas, Lim_min and Lim_max can be determined according to the
required T
Lim_min
, T
Lim_max
and T
XClk
. The time resolution when defining T
Lim_min
and
T
Lim_max
is T
XClk
. The minimum edge-to-edge time t
ee
(t
DATA_L_min
, t
DATA_H_min
) is defined
according to the section “Receiving Mode”. Due to this, the lower limit should be set to
Lim_min
³10. The maximum value of the upper limit is Lim_max = 63.
Figure 10, Figure 11 and Figure 12 illustrate the bit check for the default bit check limits
Lim_min = 14 and Lim_max = 24. When the IC is enabled, the signal processing circuits
are enabled during T
Startup
. The output of the demodulator (Dem_out) is undefined dur-
ing that period. When the bit check becomes active, the bit check counter is clocked with
the cycle T
XClk
.
Figure 10 shows how the bit check proceeds if the bit-check counter value CV_Lim is
within the limits defined by Lim_min and Lim_max at the occurrence of a signal edge. In
Figure 12, the bit check fails as the value CV_lim is lower than the limit Lim_min. The bit
check also fails if CV_Lim reaches Lim_max. This is illustrated in Figure 13.
Figure 10. Timing Diagram During Bit Check
Figure 11. Timing Diagram for Failed Bit Check (Condition: CV_Lim < Lim_min)
Bit check
Enable IC
Dem_out
Bit check Counter
0
2345
6 245
17
8
1
36
789 1112131410
1/2 Bit
15
16 17 18 1 2 3 4
56
( Lim_min = 14, Lim_max = 24 )
78
910 11 12 13
14
15 1 2 3 4
1/2 Bit 1/2 Bit
Bit check ok
Bit check ok
T
Startup
T
XClk
Bit check
Enable IC
Bit check Counter
0
2345
6 245
1 1 36
789 111210
1/2 Bit
Startup Mode
0
( Lim_min = 14, Lim_max = 24 )
Sleep Mode
Bit check failed ( CV_Lim < Lim_min )
Dem_out
Bit check Mode