Owner's manual
Table Of Contents
- 8-bit MCU with CAN controller and Flash
- 1. Description
- 2. Features
- 3. Block Diagram
- 4. Pin Configuration
- 5. SFR Mapping
- 6. Clock
- 7. Program/Code Memory
- 8. Data Memory
- 9. EEPROM data memory
- 10. In-System-Programming (ISP)
- 11. Serial I/O Port
- 12. Timers/Counters
- 13. Timer 2
- 14. WatchDog Timer
- 15. Atmel CAN Controller
- 15.1. Introduction
- 15.2. CAN Controller Description
- 15.3. CAN Controller Mailbox and Registers Organization
- 15.4. IT CAN management
- 15.5. Bit Timing and BaudRate
- 15.6. Fault Confinement
- 15.7. Acceptance filter
- 15.8. Data and Remote frame
- 15.9. Time Trigger Communication (TTC) and Message Stamping
- 15.10. CAN Autobaud and Listening mode
- 15.11. CAN SFR’s
- 15.12. Registers
- 16. Programmable Counter Array PCA
- 17. Analog-to-Digital Converter (ADC)
- 18. Interrupt System
- 19. Electrical Characteristics
- 20. Ordering Information
26 Rev.A - May 17, 2001
Preliminary
T89C51CC02
7.3.7. Reading the FLASH Spaces
User
The following procedure is used to read the User space and is summarized in Figure 11:
• Map the User space by writing 00h in FCON register.
• Read one byte in Accumulator by executing MOVC A,@A+DPTR with A= 0 & DPTR= 0000h to FFFFh.
Extra Row
The following procedure is used to read the Extra Row space and is summarized in Figure 11:
• Map the Extra Row space by writing 02h in FCON register.
• Read one byte in Accumulator by executing MOVC A,@A+DPTR with A= 0 & DPTR= FF80h to FFFFh.
Hardware Security
The following procedure is used to read the Hardware Security space and is summarized in Figure 11:
• Map the Hardware Security space by writing 04h in FCON register.
• Read the byte in Accumulator by executing MOVC A,@A+DPTR with A= 0 & DPTR= 0000h.
Figure 11. Reading Procedure
FLASH Spaces
Reading
FLASH Spaces Mapping
FCON= 00000xx0b
Data Read
DPTR= Address
ACC= 0
Exec: MOVC A, @A+DPTR
Erase Mode
FCON = 00h