Owner's manual
Table Of Contents
- 8-bit MCU with CAN controller and Flash
- 1. Description
- 2. Features
- 3. Block Diagram
- 4. Pin Configuration
- 5. SFR Mapping
- 6. Clock
- 7. Program/Code Memory
- 8. Data Memory
- 9. EEPROM data memory
- 10. In-System-Programming (ISP)
- 11. Serial I/O Port
- 12. Timers/Counters
- 13. Timer 2
- 14. WatchDog Timer
- 15. Atmel CAN Controller
- 15.1. Introduction
- 15.2. CAN Controller Description
- 15.3. CAN Controller Mailbox and Registers Organization
- 15.4. IT CAN management
- 15.5. Bit Timing and BaudRate
- 15.6. Fault Confinement
- 15.7. Acceptance filter
- 15.8. Data and Remote frame
- 15.9. Time Trigger Communication (TTC) and Message Stamping
- 15.10. CAN Autobaud and Listening mode
- 15.11. CAN SFR’s
- 15.12. Registers
- 16. Programmable Counter Array PCA
- 17. Analog-to-Digital Converter (ADC)
- 18. Interrupt System
- 19. Electrical Characteristics
- 20. Ordering Information
Rev.A - May 17, 2001 135
Preliminary
T89C51CC02
19.4.5. External Clock Drive Waveforms
19.4.6. AC Testing Input/Output Waveforms
AC inputs during testing are driven at V
CC
- 0.5 for a logic “1” and 0.45V for a logic “0”. Timing measurement
are made at V
IH
min for a logic “1” and V
IL
max for a logic “0”.
19.4.7. Float Waveforms
For timing purposes as port pin is no longer floating when a 100 mV change from load voltage occurs and begins
to float when a 100 mV change from the loaded V
OH
/V
OL
level occurs. I
OL
/I
OH
≥±20mA.
V
CC
-0.5V
0.45V
0.7V
CC
0.2V
CC
-0.1
T
CHCL
T
CLCX
T
CLCL
T
CLCH
T
CHCX
INPUT/OUTPUT
0.2 V
CC
+ 0.9
0.2 V
CC
- 0.1
V
CC
-0.5 V
0.45 V
FLOAT
V
OH
- 0.1 V
V
OL
+ 0.1 V
V
LOAD
V
LOAD
+ 0.1 V
V
LOAD
- 0.1 V