Owner's manual
Table Of Contents
- 8-bit MCU with CAN controller and Flash
- 1. Description
- 2. Features
- 3. Block Diagram
- 4. Pin Configuration
- 5. SFR Mapping
- 6. Clock
- 7. Program/Code Memory
- 8. Data Memory
- 9. EEPROM data memory
- 10. In-System-Programming (ISP)
- 11. Serial I/O Port
- 12. Timers/Counters
- 13. Timer 2
- 14. WatchDog Timer
- 15. Atmel CAN Controller
- 15.1. Introduction
- 15.2. CAN Controller Description
- 15.3. CAN Controller Mailbox and Registers Organization
- 15.4. IT CAN management
- 15.5. Bit Timing and BaudRate
- 15.6. Fault Confinement
- 15.7. Acceptance filter
- 15.8. Data and Remote frame
- 15.9. Time Trigger Communication (TTC) and Message Stamping
- 15.10. CAN Autobaud and Listening mode
- 15.11. CAN SFR’s
- 15.12. Registers
- 16. Programmable Counter Array PCA
- 17. Analog-to-Digital Converter (ADC)
- 18. Interrupt System
- 19. Electrical Characteristics
- 20. Ordering Information
Rev.A - May 17, 2001 131
Preliminary
T89C51CC02
7. Lower than standart C51 product independant from Vcc supply.
Figure 133. I
CC
Test Condition, Active Mode
Figure 134. I
CC
Test Condition, Idle Mode
Figure 135. I
CC
Test Condition, Power-Down Mode
V
CC
I
CC
(NC)
CLOCK
SIGNAL
V
CC
All other pins are disconnected.
RST
XTAL2
XTAL1
V
SS
V
CC
RST
XTAL2
XTAL1
V
SS
V
CC
I
CC
(NC)
V
CC
All other pins are disconnected.
CLOCK
SIGNAL
RST
XTAL2
XTAL1
V
SS
V
CC
I
CC
(NC)
V
CC
All other pins are disconnected.