Owner's manual

RF12
Note: The transceiver is in receive (RX) mode when bit er is set using the Power Management
Command
9. AFC Command
bit 15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0 POR
1 1 0 0 0 1 0 0 a1 a0 rl1 rl0 st fi oe en C4F7h
Bit 7-6 (a1 to a0): Automatic operation mode selector:
a1 a0
0 0 Auto mode off (Strobe is controlled by microcontroller)
0 1 Runs only once after each power-up
1 0 Keep the foffset only during receiving (VDI=high)
1 1 Keep the foffset value independently from the state of the VDI signal
Bit 5-4 (rl1 to rl0): Range limit. Limits the value of the frequency offset register to the next values:
rl1 rl0 Max deviation
0 0 No restriction
0 1 +15 f
res
to -16 f
res
1 0 +7 f
res
to -8 f
res
1 1 +3 f
res
to -4 f
res
Bit 3 (st): Strobe edge, when st goes to high, the actual latest calculated frequency error is stored into the
offset register of the AFC block.
Bit 2 (fi): Switches the circuit to high accuracy (fine) mode. In this case, the processing time is about twice
longer, but the measurement uncertainty is about the half.
f :
res
315, 433 MHz bands: 2.5 kHz
868 MHz band: 5 kHz
915 MHz band: 7.5 kHz
Bit 1 (oe): Enables the frequency offset register. It allows the addition of the offset register to the
frequency control word of the PLL.
Bit 0 (en): Enables the calculation of the offset frequency by the AFC circuit.
Tel: [phone] Fax: [phone] E-mail: [e-mail] http://www.hoperf.com