Owner manual
RC2100
2005 Radiocrafts AS RC2100 Data Sheet (rev. 1.0) Page 20 of 22
Absolute Maximum Ratings
Parameter Min Max Unit
Supply voltage, VCC -0.3 5.5 V
Voltage on any pin -0.3 5.5 V
Input RF level 10 dBm
Storage temperature -50 150
°C
Operating temperature -30 85
°C
Caution ! ESD sensitive device.
Precaution should be used when handling
the device in order to prevent permanent
damage.
Under no circumstances the absolute maximum ratings given above should be violated.
Stress exceeding one or more of the limiting values may cause permanent damage to the
device.
Electrical Specifications
T=25
°
C, VCC = 3.0V if nothing else stated.
Parameter Min Typ. Max Unit Condition / Note
Operating frequency
2400 2483 MHz
Number of channels
83
Input/output impedance
50 Ohm
Data rate
250 kbit/s
DSSS chip rate 2 Mbit/s
Modulation bandwidth
3.8 MHz -30 dBm bandwidth
Frequency stability
+/-40 ppm Over operating temperature
range
Transmit power
Power level 1:
2:
3:
4:
5:
-25
-15
-10
-5
0
dBm
Harmonics, 2
nd
and 3
rd
< -55 dBm
Spurious emission, TX
30-1000 MHz
1 – 12.75 GHz
1.8 – 1.9 GHz
5.15 – 5.33 GHz
-36
-30
-47
-47
dBm
Complies with EN 300 328, EN
300 440, FCC CFR47 Part 15
and ARIB STD-T66
Sensitivity
-94 dBm PER = 1%
Adjacent channel rejection
39 dB 5 MHz offset. PER = 1%,
wanted signal at -82 dBm
Alternate channel selectivity
55 dB 10 MHz offset. PER = 1%,
wanted signal at -82 dBm
Blocking / Interferer rejection /
desensitization
+/- 5 MHz
+/- 10 MHz
+/- 20 MHz
+/- 50 MHz
-50
-45
-40
-30
-24
-24
-24
-24
dBm
Wanted signal3 dB above
sensitivity level, CW interferer.
PER=1%
Minimum numbers corresponds
to class 2 receiver
requirements in EN 300 440
class 2
.
Saturation
10 dBm PER = 1%
Spurious emission, RX Complies with EN 300 328, EN